Foam Fire Retardant Coating - MSDS

FLAME SEAL PRODUCTS, INC.
4025 WILLOWBEND BLVD. #310
HOUSTON, TX 77025 USA
TELEPHONE # FOR MSDS INFORMATION: 713-668-4291

SECTION II - HAZARDOUS COMPONENTS

COMPONENT		ACGIH	OSHA
CAS REGISTRY NO.	WT. %	TLV	PRL
Phosphoric Acid	< 0.1%	500 ppm TWA	400 ppm TWA
7664-38-2		500 ppm STEL	500 ppm STEL

SECTION III - PHYSICAL PROPERTIES

APPEARANCE AND ODOR: White odorless liquid.

MOLECULAR WEIGHT: Not Applicable.

BOILING POINT: (DEGREES FAHRENHEIT): 212 - Not accurate: mixture of components.

MELTING POINT: (DEGREES FAHRENHEIT): Not Applicable.

VAPOR PRESSURE: (mm of Mercury): Not Determined.

SPECIFIC GRAVITY (WATER=1): 1.3 - 1.4

VAPOR DENSITY (AIR=1): Not determined.

PERCENT VOLATILE: (BY WEIGHT): 39.0% max. (water content only)

pH: 2.5 - 3.5

SOLUBILITY IN WATER: Partial with heat. Has insoluble characteristic when cool.

EVAPORATION RATE: (BUTYL ACETATE=1): Not Determined.

STORAGE: Temperature- 40-90°F, (4.44°C-32.22°C)
Time – 6 months

SECTION IV - FIRE AND EXPLOSION DATA

FLASH POINT (DEGREES FAHRENHEIT: PENSKY-MARTENS CLOSED CUP): None to boiling.

FIRE EXTINGUISHING MEDIA: Not combustible. Use water spray, fog, foam, dry chemicals, CO₂, or other agents as appropriate for material in surrounding fire.

FLAMMABLE LIMITS (PERCENT BY VOLUME): Not applicable.

SPECIAL FIRE FIGHTING PROCEDURES AND EQUIPMENT: Not combustible. Use safety equipment and clothing which is suitable for materials in surrounding fire.

UNUSUAL FIRE AND EXPLOSION HAZARDS: May liberate flammable hydrogen gas after long term storage of liquid in metal containers. Store liquid only in stainless steel, plastic or glass vessels.

HAZARDOUS COMBUSTION PRODUCTS: Combustion products can include carbon dioxide, carbon monoxide, oxides of phosphorus and traces of ammonia.

SECTION V - REACTIVITY DATA

STABILITY: STABLE ___X___ UNSTABLE _______

CONDITIONS TO AVOID: Storage of “liquid” in containers other than plastic, stain-less steel or glass. Contamination with strong oxidizers, strong alkali or strong acids.

INCOMPATIBILITY (MATERIALS TO AVOID): Strong oxidizers, alkalis, or acids. When in liquid state the product slowly reacts with some common metals causing flammable hydrogen gas to be emitted.

HAZARDOUS DECOMPOSITION PRODUCTS: Not applicable.

HAZARDOUS POLYMERIZATION: Will Occur _______ Will Not Occur ___X___

EXPOSURE FROM ROUTINE USE: No evidence of adverse effects from available information.

EFFECTS OF OVEREXPOSURE: EYES. . . Direct contact or prolonged exposure to mist may cause redness and pain. NOSE. . . Breathing of heavy concentrations of mists may cause sinus irritation and dizziness. MOUTH. . . Ingestion may cause nausea. SKIN. . . Prolonged contact may cause reddening of effected area.

DERMAL: Not established, not expected to be harmful. May be irritating with continual contact.

INHALATION: Not established. Not expected to be harmful. If necessary, use respirator if adequate ventilation is not possible to keep exposure to particulate matter at a minimum in heavy mist areas when spraying.

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Confine spilled material and absorb on sand, sawdust, earth or other available solids. Sweep and place in a suitable container. Flush with water and rinse minor spills into sewer if permitted by Federal, State and local regulations.

WASTE DISPOSAL METHODS: Mix excess FLAME SEAL-TB™ resin with T50-TB ™ Curing Agent, allow to solidify completely, then dispose in accordance with disposal methods of local regulations for non-hazardous solid waste.

CLEAN WATER ACT REQUIREMENTS: Section 311 of the Clean Water Act lists phosphorus as a hazardous substance which, if discharged into or upon water, will present an imminent and substantial danger to public health and welfare. Spills of 5000 pounds or more must be reported to the National Response Center @ 1-800-424-8802.

RESOURCE CONSERVATION AND RECOVERY ACT (RCRA) REQUIREMENTS: No applicable information found.

TSCA: All components of this product are on the TSCA Inventory or are exempt from TSCA Inventory requirements.

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Keep away from eyes. Avoid prolonged contact with skin. Wash exposed skin with soap and water. Avoid breathing of mist.