LEATHER SEAL™  2

Leather Seal™ 2 Fire Retardant  offers a 10-15% increase in efficiency compared to the original product, plus adjustments to the pH and formulation that eliminate conflicts with most dyes & other tanning process chemicals. (As verified in tests performed by clients in our pilot test program.)

Leather Seal ™ 2 Fire Retardant  is a non-toxic water based fire retardant designed for use on leather upholstery.  Since its introduction, Leather Seal ™ 2  has gained acceptance in the industry because of its high quality, ease of application, and low cost. This product contains no VOC’s and does not cause linear shrinkage. Real time testing has proven  Leather Seal ™ 2 does not cause discoloration upon application or after time. It has also been proven by our customers that the product does not affect the cohesion between leather and adhesives.

Recommended Use:
Interior-Leather Seal ™ 2 Fire Retardant is a spray applied product designed to be applied to the unfinished side of the leather.  Spray at approximately 100-150 square feet per gallon, then dry.

Environmental Regulations:
This  product complies with U.S. Federal Regulations concerning the use of lead in paint and hydrocarbon emissions.

The following methods have been reported by some of our customers.  We are providing this information for your reference to help you design a method that is specific to your particular manufacturing process, choice of specific dyes and tanning chemicals.

By Spraying: Spray on the back side of the finished leather at a rate of one gallon per 100 - 150 square feet.

In the Dry Drum:  Application is performed via chemical dosing in the dry drum with a running time of 90 minutes.  This should be done after the leather goes through the staking stage.  After the leather has been treated in the Dry Drum it is recommended to toggle dry it again.  (Toggle dryers should be used as the method to dry the leather).  If too much chemical remains on the finished side, white solid residues might build up.  If this occurs the surface must be wiped with some type of conditioner before it goes to the finishing stage.  This way the residues will not be sealed with the lacquers etc..

Atlas Refinery:  973 589 2002 office,  973 589 7377 fax.,    www.atlasrefinery.com   ,   info@atlasrefinery.com