WOOD FIRE RETARDANT APPLICATION

1.  WOOD TO BE TESTED MUST BE UNTREATED, UNPAINTED, CLEAN AND DRY.

2.  BRUSH, ROLL, OR SPRAY BOTH SIDES OF WOOD SAMPLE IF POSSIBLE.  APPLY AMPLE WOOD SEAL TO SATURATE THE WOOD.

3.  USE PRODUCT IN AREA WITH ADEQUATE VENTILATION.

4.  ALLOW TIME TO DRY.

5.  TEST BURN WITH A FLAME OR TORCH TO CHECK THAT THE WOOD DOES NOT CONTINUE TO BURN WHEN THE FLAME IS REMOVED.

*** ( NOTE: THE CHEMICAL MUST BE USED IN ITS " UNDILUTED" STATE. ) ***
 

WOOD TREATMENT:

APPLY WOOD SEAL FLAME RETARDANT TO THE WOOD BY SAME METHOD AS THE SUCCESSFULLY TESTED SAMPLE.

COVERAGE RATE SHOULD BE 150 - 350 SQUARE FEET PER GALLON.

ALLOW WOOD SEAL TO DRY.

EXTERIOR - IF THE WOOD SURFACE WILL BE EXPOSED TO WATER - A NON-FLAMMABLE PAINT OR COATING SHOULD BE APPLIED AS A TOP COAT AFTER  Wood Seal^™ HAS DRIED.